A Ray's company - serving North Las Vegas, NV

Rheem Ductwork Repair in North Las Vegas, NV

AC repairAC repair
Furnace & heatingFurnace & heating
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Rheem Ductwork Repair: The North Las Vegas Owner’s Guide

Rheem-compatible ductwork repair in North Las Vegas typically runs $350 to $1,400 installed, depending on whether it’s a sealed joint, a collapsed flex run in the attic, or a full trunk-line rework, and most of it we can get to same-day or next-day because we know these systems and we don’t make you wait a week for a callback. We also do it under the 90-Day Done Right Promise in writing, so if a joint we sealed opens back up, one call brings me back.

Call (844) 761-6871

Most North Las Vegas owners find out something’s wrong with the ducts the same way: a room that never gets cool no matter what the thermostat says, a power bill that jumped $40 or $60 between two mild months, or attic insulation that suddenly looks like it’s been through a dust storm. Sometimes it’s the flex duct sagging off its collar at the plenum. Sometimes the inner liner has torn and you’re cooling your attic instead of your living room. The system isn’t broken. The delivery path is.

Key Takeaways

  • Installed ductwork repair in North Las Vegas usually lands between $350 and $1,400.
  • Rheem systems use standard round and rectangular duct sizes, but collar and plenum connections are where matching matters.
  • Most leaks we find here happen at joints and collars, not in the middle of a run.
  • We don’t claim to stock parts on a truck. We diagnose what’s actually wrong, then source the right Rheem-compatible piece for your model.

Which Rheem Models This Applies To

Ductwork repair on a Rheem system is mostly about the air handler and plenum, not the model number on the outdoor condenser. If you’ve got a Rheem Classic, Rheem Prestige, Rheem Achiever, or one of the newer Rheem RP series units, the duct side of the system works the same way: a supply plenum off the top of the air handler feeding trunk lines, then branch runs to each room. What changes across Rheem models is the physical size of the air handler cabinet and where the plenum connections land, and that’s why a generic collar won’t always seat clean on a Rheem cabinet the way it will on a Carrier, Trane, or Lennox.

To identify what you’ve got, look at three things. First, the data plate on the indoor air handler (not the condenser outside) – it’ll list the model and tonnage. Second, the duct size at the plenum (most North Las Vegas homes run 14-inch or 16-inch flex or hard pipe off a 3-ton or 4-ton Rheem air handler). Third, the condition of the inner liner, which you can only really see from the attic access. Write down the model, take a photo of the plenum, and we can usually tell you over the phone whether the piece you need is a standard Rheem-compatible collar or a custom transition.

On the OEM-vs-aftermarket question: for ductwork, OEM matters far less than it does for control boards or blower motors. Rheem doesn’t manufacture flex duct or sheet-metal plenums. It uses standard materials specified to certain R-values and diameters. A quality aftermarket boot, collar, or flex run that matches the spec will do the job for a decade or more. We’re an independent North Las Vegas service company – not affiliated with Rheem – and we’ll tell you honestly when aftermarket is fine and when the spec needs the exact match.

Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Signs Your Rheem Ductwork Repair Is Failing

  • One or two rooms never cool (or never heat). That’s usually a disconnected branch run or a crushed flex duct in the attic. In North Las Vegas summers, flex duct that was zip-tied and never strapped properly sags against heat-soaked attic framing and collapses on itself.
  • The bill spikes but the house doesn’t cool any faster. That’s a leak on the supply side. You’re paying to cool the attic. If you see attic foil or insulation dust coating a joint, that’s the tell.
  • Whistling or rushing-air noise from a vent or a wall cavity. A joint has separated or a boot has pulled loose from a ceiling register. Common in older single-story North Las Vegas homes east of I-15 where attic flex has aged out.
  • Dust on every surface after the system runs. A torn inner liner on flex duct is pulling attic air and insulation fibers into the airstream. This is the one you don’t wait on.
  • Condensation or staining on a ceiling in July or August. A leaking duct in a 110-degree attic hits cold supply air and sweats, or a poorly sealed plenum connection is dripping down a joist. Wet drywall means stop running the system and have it looked at.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here in North Las Vegas, most Rheem ductwork repairs fall into three buckets, and we quote from the same ranges every time so you know upfront what you’re looking at:

  • Sealing a handful of joints or reattaching a boot: $350 to $550.
  • Replacing one or two damaged flex runs (supply or return): $450 to $850.
  • Plenum transition repair or partial trunk-line rework: $850 to $1,400.

The range comes down to attic access (some North Las Vegas homes have a 24-inch scuttle, which slows everything down), whether the existing duct is flex or hard pipe, and how many connections actually need sealing versus how many looked fine in photos but failed when we got up there. You’ll see the photos and the numbers before anyone touches a thing. Parts and labor are itemized, and the work carries the 90-Day Done Right Promise in writing. If a joint we sealed leaks again, one call brings me back.

DIY or Call Us?

There’s an honest split here, and I’d rather you know it than guess.

What’s safe to check yourself: filter condition (clogged filters stress the whole system), visible register grilles for dust or debris, and the thermostat reading versus an actual thermometer in the room. If the register is blowing strong and the room is still hot, the duct is the issue – not the filter.

Where DIY goes wrong: the attic. North Las Vegas attic temperatures can hit 150 degrees in July, and no duct repair is worth a heat-stroke call to 911. There’s also a real safety concern here that people underweight: on older North Las Vegas homes built in the 1970s and ’80s, attic duct runs sometimes sit near or under blown insulation above electrical junction boxes, and moving ducts around without knowing what’s underneath is how you start a fire. If you don’t know your attic, don’t crawl it in August. Call us at (844) 761-6871 and we’ll get a live person on the phone right now – not a callback system.

Frequently Asked Questions

Need HVAC help nationwide? Licensed & insured · within the hour response · free estimates
Call (844) 761-6871
Local Service Coverage

Request a Free Estimate in North Las Vegas

Tell us what you need - Ray's Heating & Air North Las Vegas responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch