AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Ductwork Repair: The North Las Vegas Owner’s Guide
Ductwork repair on a Lennox system in North Las Vegas usually runs $150 – $650 installed, and most torn flex runs, separated plenum joints, and crushed trunk sections we see get fixed the same day. We’re an independent service provider, not affiliated with Lennox. If your electric bill jumped 40% between June and August, an upstairs bedroom won’t cool no matter what the thermostat says, or you can hear the blower straining like it’s breathing through a straw, suspect the ducts before the equipment.
North Las Vegas homes built during the 2003 – 2008 boom in Aliante and the older 1990s builds off Carey Avenue share one failure: attic flex duct that’s been baking at 150°F attic temperatures for two decades. The inner liner dries, cracks, and starts leaking cool air into the attic before you ever notice a symptom. By the time you feel it, you’re paying to air-condition the rafters.
Which Lennox Models This Applies To
Ductwork is ductwork at the equipment end, so almost any Lennox air handler or packaged unit will mate to standard R-6 or R-8 flex, sheet metal trunk, and the plenum transitions we fabricate. What matters more is the Lennox cabinet size and the collar orientation. A Lennox Signature collection air handler sitting in a horizontal attic configuration has different supply plenum clearances than a Merit series vertical unit in a closet. We measure before we order.
Two things to check yourself on the data plate before any work is quoted. First, the model number prefix tells us the series and cabinet width. Second, the physical return-air opening measurement at the unit – Lennox has used both 20×25 and 24×24 returns depending on tonnage and series, and a mismatch here is why some North Las Vegas quotes come back $200 higher than others.
On OEM versus aftermarket: Lennox-branded flex duct and fittings are quality, but the markup is real. For duct repair specifically, we recommend R-8 insulated flex or fabricated sheet metal from a reputable manufacturer. It meets the same code and performs identically. There’s no proprietary Lennox chemistry in a duct run. Any contractor who tells you otherwise is selling a label, not a fix. We’ll show you both numbers and let you pick.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Signs Your Lennox Ductwork Repair Is Failing
- Rooms that never cool, especially on the west side of the house. This usually means a disconnected or torn flex run feeding that room. The air handler is running fine, but the cool air is dumping into the attic instead of the bedroom.
- Dust puffing from supply registers when the blower kicks on. A return-side leak is pulling attic insulation dust and fiberglass into the airstream. That dust is going into your home, not out of it.
- Rising electric bills with no equipment change. A leaking duct system in a 130°F North Las Vegas attic can lose 20 – 30% of the cooling before it reaches the register. You’re paying for air that never arrives.
- Whistling or roaring at the return grille. Undersized or crushed return duct, common in older homes where a remodel or a new water heater install pinched the return run. The blower is starving.
- Condensation on supply registers or a musty smell. Duct insulation has failed and cold air is sweating inside the chase. In summer humidity from the monsoon season this turns into mold in a hurry.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed ductwork repair in North Las Vegas lands in the $150 – $650 range for typical repairs. Here’s how it breaks down:
- Single flex run replacement (torn, disconnected, crushed): $150 – $300. Includes R-8 flex, tape, mastic, and sealing at both ends.
- Plenum repair or re-tape at the air handler: $200 – $400. Includes mastic sealing at the cabinet and trunk.
- Trunk line section replacement or multiple runs: $350 – $650. Includes fabrication, R-8 insulation, and pressure testing where accessible.
Every job is quoted after the readings, not before. We’ll show you the static pressure at the plenum and the temperature split, so you see why it’s short on airflow and what the repair will actually fix. The 90-Day Done Right Promise is in writing on every job. If a seal we made fails or a run we replaced comes loose, one call brings us back.
DIY or Call Us?
You can safely check a few things without touching anything sharp or energized. Walk the attic in the morning when it’s cool and look for separated flex, duct tape that’s turned to dust, and crushed runs under plywood walkways. Check that all supply registers have airflow. Turn the system off at the thermostat before you do any of that.
Where DIY goes wrong: mastic and foil tape on a 130°F attic fitting in July is miserable work, and the seal fails within a season if the surface isn’t prepped right. More importantly, cutting into a supply plenum or moving a flex run near the air handler means working around line voltage, refrigerant lines, and the drain pan. This isn’t dangerous like spring work, but you’re in tight attic space in extreme heat with energized equipment nearby. We measure static pressure before and after the repair so you know it worked, not just that it looks taped. Call (844) 761-6871 and we’ll come look – No Trip Charge inside Clark County, and a Free Second Opinion on any written estimate you already have.
FAQs
Expect 12 to 18 years for attic flex in North Las Vegas. Homes built between 2003 and 2008 in Aliante and the northern valley are squarely in the failure window now. Above 140°F attic temps in July and August break down the inner liner faster than anywhere else in the country.
Yes for most single-run tears and separated collar joints. We re-tape with mastic, re-secure the collar, and pressure-check it. If the flex inner liner is cracked along a long section, partial replacement is the right call because re-taping a dried liner just delays the problem another year.
Most single-run repairs take 1 to 2 hours. Trunk section replacement or multiple runs usually runs 3 to 5 hours depending on attic access. We schedule the same day when we can, and we’ll give you an honest window on the phone.
We buy locally from North Las Vegas and Las Vegas HVAC supply houses – R-8 insulated flex, sheet metal, mastic, and foil tape. We don’t stock parts on a truck, so the material is matched to your Lennox cabinet and measured on-site before it’s ordered. That means right-fit the first time, not a return trip to swap the wrong size.
Summer in North Las Vegas is not the time to find out your attic ducts have failed. Call (844) 761-6871 for a free estimate – live person answers, around the clock, every day. Readings first, numbers second, and the 90-Day Done Right Promise in writing.
Written by the team at Ray’s Heating & Air North Las Vegas, serving North Las Vegas and nearby areas.