Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateRheem Heating & Furnace in North Las Vegas: What to Know First
We repair and service Rheem furnaces and heating systems in North Las Vegas as an independent Rheem service provider, and most furnace repairs here get done in a single visit. Diagnostic and repair work typically runs $150 – $700 depending on what’s actually wrong, and you see the meter readings and the number before anyone turns a wrench. If it’s a control board or a gas valve, we may need to order the part, so figure a day or two on those. Everything else is usually same-day.
This page is for the person who owns the Rheem down in the garage or the closet and wants to know what’s likely wrong, what it should cost, and who’s actually going to show up. That would be Ray. Call (844) 761-6871 and a live person picks up, day or night.
How Rheem Products Fail – and How We Fix Them
Rheem builds a solid furnace. The failures we see in North Las Vegas are specific, and once you’ve worked on a few hundred of them, the symptoms start pointing to the same handful of causes. Here’s what shows up most.
- Hot surface igniters on the RGRL and RGRM Classic series. The igniter is a thin silicon nitride element that gets red-hot every cycle and eventually cracks. You’ll hear the draft inducer spin up, then nothing – no click, no flame, just the blower running cool air. A lot of folks assume it’s the gas valve. It’s almost always the igniter, and we test it with a meter for continuity before quoting anything. Igniter replacement is one of the cheaper repairs we do.
- Flame sensors on the Rheem Prestige and R96V modulating furnaces. The sensor rod collects oxidation and stops proving flame, so the burner lights for a few seconds and shuts off. Short-cycling like that is a classic sign. We pull the sensor, clean it, and check the microamp reading – if it’s weak, we replace it rather than just cleaning and hoping.
- Inducer motor bearings on older Rheem units past the ten-year mark. These motors sit in the flue path and the heat wears the bearings down. You’ll hear a rumble or a squeal at startup. Left alone, the pressure switch won’t prove draft and the furnace locks out. Replacing the motor before that happens saves you a cold night.
- Cracked heat exchangers in high-cycle furnaces. This is the one we take seriously. North Las Vegas winters swing hard – 70s in the afternoon, low 30s by morning – so furnaces here cycle more than in a milder climate, and that thermal stress is what cracks a heat exchanger over time. A cracked exchanger can let carbon monoxide into the supply air. If we find one, we shut the furnace down and tell you straight. Repair or replace depends on the age and the warranty.
- Gas valve and pressure switch faults on the Rheem R801T and similar 80% single-stage models. A sticking gas valve or a pressure switch that won’t close will leave you with a furnace that lights sometimes and not others. We test gas pressure at the manifold and the inlet before we ever say “gas valve” – half the ones we’re called out on turn out to be a dirty pressure switch port.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Our Rheem Heating & Furnace Process
Every Rheem job follows the same order, whether it’s a $180 igniter or a heat exchanger decision. Readings first, numbers second – you’ll see both.
- 1
The call. A live person answers, including at two in the morning, and that person is Ray. You tell us what the furnace is doing. We ask a couple of questions so we can load the right parts for a Rheem on the way out.
- 2
Diagnostics at the furnace. We pull the blower door and run through the sequence: inducer, pressure switch, igniter, flame sensor, gas pressure, temperature rise. The meter readings get written down and shown to you. We don’t guess at a part and we don’t start throwing parts at it.
- 3
The parts decision. Some Rheem parts have a quality aftermarket equivalent that’s fine and saves you money. Others – control boards, heat exchangers, gas valves – we go OEM, because the aftermarket versions on those have a habit of failing early. We’ll tell you which is which and what each costs. You decide.
- 4
The repair. The person who diagnosed it does the work. Same face, not a rotating crew who’s never seen your system. Background-checked, and the job gets done to Rheem’s specs so your warranty stays intact.
- 5
The test. We fire it up and watch the full cycle – ignition, blower, temperature rise across the exchanger, shutoff. We don’t leave until it’s running right and the numbers are where they should be.
- 6
The promise. Every heating job carries the 90-Day Done Right Promise in writing. If something’s not right, one call brings Ray back. No runaround.
What Rheem Heating & Furnace Costs in North Las Vegas
Here’s what Rheem work actually runs in North Las Vegas. These are the ranges we quote, and the price you hear on the phone is the price at the door.
| Rheem Job | Typical Range |
|---|---|
| Furnace tune-up | $80 – $200 |
| Igniter replacement | $150 – $350 |
| Flame sensor / pressure switch | $150 – $300 |
| Inducer motor replacement | $350 – $700 |
| Gas valve or control board | $400 – $700 |
| Furnace replacement | Quoted per job after a load check |
What moves the number: the model (a modulating Prestige costs more to fix than an R801T), whether the part is OEM or aftermarket, and whether it’s a weekend or after-hours call. What doesn’t move it is how you found us. Estimates are free, and if you’ve got a written estimate from someone else, we’ll give you a free second opinion on it. Call (844) 761-6871.
See the difference
Before
After
Before
After
Before
AfterWhy North Las Vegas Homeowners Call Ray’s Heating & Air North Las Vegas for Rheem Work
Ray’s Heating & Air North Las Vegas has been locally owned and owner-operated since 2002. The name, address, and license number are published – you can check them before you call. The person who answers the phone at two in the morning is the same person who shows up at your door. Some houses, Ray’s been to four times in six years, and it’s been Ray every time.
Our technicians have up to 24 years of experience, and they’ve worked on enough Rheem units in North Las Vegas to know the igniter from the gas valve before the meter comes out. We also service Carrier, Trane, and Lennox, so if your Rheem turns out to be a replace-not-repair call, we’ll quote you honestly on whatever brand fits your house and your budget – not just the one we like. Upfront pricing, background-checked techs, and the 90-Day Done Right Promise on every heating job.
FAQs
Not if it’s done right. We use OEM parts on the components Rheem’s warranty covers – heat exchangers, control boards, gas valves – and we document the work so you’ve got a paper trail. As an independent Rheem service provider we’re not affiliated with Rheem, so we can’t file the claim for you, but we’ll give you everything you need to. Most Rheem furnaces carry a parts warranty worth protecting, so it’s worth the call. Call (844) 761-6871 for a free estimate.
Usually, yes. Igniters, flame sensors, pressure switches, and inducer motors are the common ones and we can typically get them the same day. Control boards and heat exchangers sometimes take a day or two to source. We’ll tell you upfront which category your part falls into before you commit to anything.
Same-day on most calls, and we answer live around the clock for no-heat emergencies. A furnace that quits in a North Las Vegas cold snap isn’t something to sit on – we treat no-heat calls as priority. Call (844) 761-6871 and we’ll tell you honestly how soon we can be there.
Depends on the age and the diagnosis – we’ll tell you straight rather than sell you a new one. As a rule: under ten years old with a failed igniter, sensor, or motor, repair it. Past 15 years with a cracked heat exchanger or a failed control board, replacement usually makes more sense than sinking money into it. We give you the numbers both ways and let you decide. Call (844) 761-6871 for a free estimate.
A full sequence check, cleaning of the flame sensor and burners, gas pressure and temperature-rise readings, and a written report of what we actually found – for a flat $80 – $200. Technicians aren’t paid on what they sell, so the report is the report. Call (844) 761-6871 to book one.
Let’s Get Your Rheem Heating Right
If your Rheem furnace is acting up in North Las Vegas, call (844) 761-6871 for a free estimate. A live person answers, the diagnostics are real, and you’ll see the readings before you see a price. If it’s not done right, one call brings Ray back.
Written by the team at Ray’s Heating & Air North Las Vegas, serving North Las Vegas and nearby areas.