Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Heating & Furnace in North Las Vegas: What to Know First
We provide independent Lennox heating and furnace service in North Las Vegas, and most furnace repairs are finished the same day, usually in two to four hours once you’re on the schedule. Repairs run $150 to $700 depending on what’s actually broken, and when we quote a replacement or install it’s a fixed price in writing, not a phone number that climbs. As an independent Lennox service provider, we’re not affiliated with or authorized by Lennox; we just work on their equipment every week and know its habits.
This page is for the homeowner who already knows their system says Lennox somewhere on the cabinet. Call (844) 761-6871 for a free estimate and a live person answers, every day, around the clock.
How Lennox Products Fail – and How We Fix Them
Lennox furnaces and air handlers are strong machines, but they have a handful of known failure points that show up in North Las Vegas homes again and again. Here’s what we actually see when we take the panel off.
- Hot-surface ignitors on the G60 and Elite series. The ignitor gets hairline cracks and the furnace either won’t light or lights and then drops out after a few seconds. It’s a $150 to $300 fix with the part, and the symptom is easy to confuse with a gas valve problem. We test the ignitor’s resistance before anyone touches the valve.
- Flame sensors on Merit series furnaces. A carbon-fouled sensor tells the control board no flame is present even when it’s burning fine, so the furnace short-cycles. We clean it, check flame rectification in microamps, and only replace it if the reading stays weak after cleaning.
- Draft inducer motor noise on older Lennox units. Housings get dry and bearings wear. In our dry North Las Vegas air we see this on units older than about 12 years more than anywhere else; you’ll hear a rumbling at startup that used to be silent. On these we check for proper vent pressure before replacing the motor, since a blocked flue looks the same from the outside.
- Heat exchanger cracks on the G26 and older mid-efficiency furnaces. These are the units we shut down and tell you to replace. A failed heat exchanger leaks carbon monoxide into the supply air. It is the one condition where we hand you a replacement quote and a red tag, and we never sell a repair on a cracked exchanger.
- Ignition control board failures on the SL280 and Signature series. The board is the most expensive single part on these furnaces, so we meter every input first: incoming line voltage, the 24-volt transformer, flame sensor signal. If the board’s bad, our best move is often a quality aftermarket board over original equipment to save you money. We’ll tell you which one and why before we reach for either.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Our Lennox Heating & Furnace Process
- 1
Call. A live person answers, day or night, and books you in for the next available slot. We ask your model number so we arrive with the common parts for that furnace on the truck.
- 2
Diagnose. Readings first, numbers second. We meter the ignitor, the flame sensor, gas pressure in and out of the valve, static pressure, and the heat exchanger. You see every number before you’re quoted a dime.
- 3
Decide the part. For some Lennox parts we go original equipment because the knockoff won’t hold up. For others we’ll show you a quality aftermarket option that saves real money without cutting life short. You make the call with the numbers in front of you.
- 4
Repair. We shut off gas and power to the furnace while it’s under the wrench. Because it’s gas-fed equipment, we do not talk anyone through this over the phone. It’s not a job to attempt yourself.
- 5
Test and clean up. We run the furnace through a full heat cycle, check the temperature rise against the data plate, and confirm carbon monoxide in the flue is safe with a combustion analyzer. Then we pack out the old parts and leave the closet cleaner than we found it.
- 6
Guarantee. Every heating job carries the 90-Day Done Right Promise in writing. If it’s not right, one call brings Ray back.
See the difference
Before
After
Before
After
Before
AfterWhat Lennox Heating & Furnace Costs in North Las Vegas
Here’s what these jobs actually cost in North Las Vegas. The numbers hold across the city; what moves them is part availability and how deeply the furnace is buried in a closet or up in the attic.
- Lennox furnace repair, common ignitor or flame sensor: $150 to $700. Most single-part repairs land around $150 to $400.
- Lennox tune-up: $80 to $200. Includes a written report of what we found, not just a sticker.
- Lennox furnace replacement, full install: a fixed written price set after we’ve load-checked the home. That’s not a flat same-day number, and anyone who quotes you one over the phone is guessing.
Old ductwork, tight attic access, and a home that needs a bigger furnace all push the price up. Call (844) 761-6871 for a free estimate. Written estimates come with a free second opinion from us if you got one somewhere else.
Why North Las Vegas Homeowners Call Ray’s Heating & Air North Las Vegas for Lennox Work
Ray’s Heating & Air has been locally owned and owner-operated since 2002, and when you call you get either Ray or a background-checked technician who has done this a long time. Our technicians have up to 24 years of experience. Ray answers his own phone at two in the morning. Background-checked, uniformed technicians with continuity means the person who shows up has seen this kind of system before. Every heating job carries the 90-Day Done Right Promise in writing.
We aren’t a Lennox dealer, but we work on Lennox all week, and we also handle Carrier and Trane. Ask anyone on your street. Published address, published license number, real numbers before work begins.
FAQs
Only if non-approved parts are used or the install doesn’t follow manufacturer spec. We always check whether your Lennox is still under a parts warranty before we quote, and we’ll use original equipment parts when that’s what keeps the coverage intact. Call (844) 761-6871 and we’ll look it up with you.
Yes. Common Lennox parts like ignitors, flame sensors, and aftermarket control boards we can get fast, and if it’s a specialty part we’ll tell you the wait on the first call before you commit. We’d rather give you an honest timeline than promise a part we can’t find.
Repair if the repair is under $700 and the furnace is under about 12 years old with a sound heat exchanger. Replace if the exchanger is cracked, the repair costs more than a third of a new system, or you’re on your third repair this season. We’ll give you both numbers and let you decide. Call (844) 761-6871 for a free estimate.
Most Lennox furnace calls in North Las Vegas get same-day service if you call before mid-afternoon, and we answer around the clock for no-heat emergencies. A failed furnace in a cold snap is a health risk, so don’t sit on it. (844) 761-6871.
A full check of ignitor, flame sensor, gas pressure, heat exchanger, and flue with a combustion test, and a written report of what we found. $80 to $200 and nobody on our crew is paid on what they sell. Call (844) 761-6871 to book one.
Written by the team at Ray’s Heating & Air North Las Vegas, serving North Las Vegas and nearby areas.